3d-stuff/openscad/own/universal rostock endstop h.../remix cherry switches/holder.scad

126 lines
2.7 KiB
OpenSCAD

// universal endstop holder for rostock delta printer
// by zeus - zeus@ctdo.de - CC-BY-NC-4.0
// -> https://www.thingiverse.com/zeus
// -> https://github.com/zeus86
// 2014-09-21
//
// edit "module wall" for your needs if not using "sainsmart mechaical endstop pcb"
// for further instructions look at the comments above the "wall"-module in this code.
//
// ===================================================================
//
//rod-diameter, set a bit thicker than the rod really is
rod_dia=8.5;
//center-to-center distance of the rods; set a bit smaller than the original 60 to keep the bearings smooth
rod_distance=59.7;
// overall thickness
material_t=2.0;
// mounting-wall thickness
wall_t=5;
//overall height
holder_h=20;
//diameter of the holes
hole_dia=3;
//cone cut-in of the holes for easier screw insertion; set to "0" if not needed
cut_in=1;
wall_w=rod_distance-material_t*2+rod_dia/2-1;
$fn=30;
// ===================================================================
module hex_standoff(){
rotate([90,0,0]){
translate([-rod_dia*0.66,holder_h/2,0]){
difference(){
cylinder(r=holder_h/1.75,h=rod_dia+material_t,center=true,$fn=6);
cube([rod_dia/1.5,rod_dia/1.5,rod_dia+material_t],center=true);
}
}
}
}
module clip(){
difference(){
union(){
//outer cylinder
cylinder(r=rod_dia/2+material_t,h=holder_h);
//outer hex standoffs
hex_standoff();
}
//inner cylinder
cylinder(r=rod_dia/2,h=holder_h);
//cutout
translate([-rod_dia,0,holder_h/2]){
cube([rod_dia*2.5,rod_dia/1.25,holder_h+0.1],center=true);
}
}
}
module hole(){
rotate([90,0,0]){
cylinder(r=hole_dia/2,h=wall_t*2, center=true);
if (cut_in==1) {
cylinder(r1=0,r2=hole_dia*0.6,h=wall_t*1.01,center=true);
}
}
}
// ===================================================================
// Edit the module below to add the holes you want to appear in the center-part.
// should be mostly self-explaining
//
// translate([-22,0,3]){
// hole();
// }
//
// this example code creates a hole, which is moved by -22mm(x), 0mm(y), and 3mm(z)
// measured from the absolute center of the coordinate-system (enable under "View -> Show Axes").
// ===================================================================
module wall(){
difference(){
translate([0,0,holder_h/2]){
cube([wall_w-material_t*4,wall_t,holder_h],center=true);
}
union(){
translate([-22,0,3]){
hole();
}
translate([0.2,0,3]){
hole();
}
translate([-22,0,13.3]){
hole();
}
translate([0.2,0,13.3]){
hole();
}
}
}
}
//left clip
translate([-rod_distance/2,0,0]){
clip();
}
//right clip
translate([rod_distance/2,0,0]){
rotate([0,0,180]){
clip();
}
}
//wall
wall();